How are the concentrations of sugar affect the amount of alcohol produced after
fermentation of yeast?
Anaerobic respiration in yeast is known as fermentation. Yeast
is a fungal microorganism that remains a common component of modern wine and
bread manufacture. Fermentation is the scientific process that yeast metabolizes
sugars and releases alcohol and carbon dioxide. Yeast contains enzymes that catalyze the
breakdown of glucose to ethanol and carbon dioxide.
Cell respiration involves the production of ATP using energy
released by the oxidation of glucose and the first stage of cell respiration
for glucose as a substance is a metabolic path way called glycolysis. Glucose
is partially oxidized in the pathway and a small amount of ATP is produced. The
glycolysis process can be achieved without using oxygen therefore the
glycolysis can form part of both aerobic and anaerobic respiration. Glycolysis
converts one glucose into two pyruvates. Two ATP molecules are used per glucose
and four are produced so there is a net yield of two ATP molecules. This is a
small yield of ATP per glucose, but it can be achieved without the use of any oxygen,
which is anaerobic respiration. Two NADs are also converted into two reduced
Concentration of pineapple juice (100%, 80%, 60%, 40%, 20%)
The amount of alcohol that produced (in %)
(how to control, why is it important)
Amount of yeast
Amount of pineapple
The more concentrated pineapple juice, the more sugar
contained. In the higher concentrated solution, the amount of ethanol will
produced more due to the higher rate of fermentation of yeast.
Knife and chopping board
300 mL Beagers
1000 mL Beager
100 mL measuring cylinder
Peal and cut pineapple into small pieces
Put all the pineapple in the blender and blend
it until the pineapple become puree then put it in the filtered to percolate
the pineapple garbage and store the pineapple juice in 1000 mL beager. Make
sure that the pineapple juice doesn’t have anything in it.
Dilute the pineapple juice into 5 concentrations
by adding the distilled water using the measuring cylinder to measure and mix
it together in amount that shown in a table below:
Pineapple juice (mL)
Distilled water (mL)
*mix the pineapplr juice and distilled water in 300 mL
Take a sample of pineapple juice in each
concentration before add the yeast, place the hydrometer and record the
Use measuring cylinder to measure 200 mL of
pineapple juice for 5 concentrations using 100 mL measuring cylinder and pour
in the 5 different 300 mL beagers.
Weigh 5 grams of yeast power using electronic
balance with electronic balance and pour 5 grams of yeast in each beagers for
each concentration and make sure that the yeast power goes in at the same time.
Mix the yeast and pineapple juice with the
stirring rod until the solution completely mixed.
Cover the beagers with parafilm to prevent other
substances to fall in and make a small hole on the film for the gas produced
(carbon dioxide gas) to move out and prevent the burst of high pressure gas
Keep the beagers close for 3 days to let the
3 days, stir the solution and pour the solution in the distillation flask. Make
sure that the solution doesn’t go over two thirds of the flask to prevent the
solution that might propel into the condenser, compromising the purity of the
11. Place the flask in the thermowell heat
source and set up the distillation as the diagram below:
the temperature and keep in constant at 77-82 (ethanol boils at 78 )
13. When the product of distillation reaches 100
mL in receiving flask remove the heat source.
14. Repeat the process of distillation for all
concentrations and all concentrations in the same trial need to distil in the
steps 4-13 for trial 2 and trial 3.
16. Place all the distilled solutions in the ice
bath and wait until the temperature lower and reach 15 (temperature that hydrometer work best)
the hydrometer in each solution and record the final gravity.
18. All the solutions, chemical, and waste from
the lab can pour it in the sink since it’s not toxic and won’t have any effect
to the environment.
Calculation the percentage of ethanol using equation:
Uncertainty of starting gravity =
Uncertainty of final gravity =
Total uncertainty = 0.001 +0.001
% Of ethanol
Calculate the average of % of
pineapple juice (%)
% Of ethanol